Raise the vehicle in order to access the system bleed screws. Bleed the system at the right rear wheel first.
Suck out as much of old the fluid using the turkey baster.
How to bleed brake lines on a 2000 chevy silverado.
Follow these steps to attach your pressure bleeder to your braking system and purge the worn and contaminated brake fluid from your brake lines.
Here is an instructional video on how to bleed and flush your brake system.
Dan the fix it man 191821 views.
Slowly depress the brake pedal.
Remove your existing brake fluid reservoir cap.
Check the level of the brake fluid in the master cylinder and top off if necessary.
Continue bleeding the other three corners of the truck.
This was done on a 2007 chevy silverado.
Install a clear hose on the bleed screw.
Immerse the opposite end of the hose into a container partially filled with clean dot 3 brake fluid.
Do not let the master cylinder run out of brake fluid or else air will enter the brake system and you will have to start the brake bleeding process over again.
2005 chevy silverado single spring rear brakes brake shoes drum and wheel cylinder replacement duration.
This is probably the similar procedure for more most vehicles.
Bleeding the brakes o a chevy silverado part one.
Open the bleed screw 12 to one full turn.
Fill your sprayer with two to three quarts of clean brake fluid.
No comments:
Post a Comment